How to Replace a Brass Faucet Cartridge

If your faucet's cartridge won't move, it's time to replace it. A brass faucet has a retaining nut located at the base of the handle, holding the cartridge in place. To remove this nut, find the plastic retaining ring, and then unscrew it using a pipe wrench or water pump pliers. Pull up on the pin on the cartridge to remove it. A new cartridge will fit right in the handle, and you can then reassemble the faucet.

When replacing a cartridge, you should first remove any decorative covers on the handles. If your faucet hardware has a crystal ball decoration, you will need to unscrew the cap before you begin. Otherwise, you can simply use a flat head screwdriver to unscrew the plastic caps. Once the caps are removed, you should see the screw. After that, you'll want to remove the old cartridge. Once the old one is removed, you can proceed to replace it with a new one.

Once you've removed the old cartridge, you can install a new one. This may be easier than replacing a faucet cartridge, as you only need to remove the handles. Using a wrench, unclip the retaining clip, and then unscrew the stem from the handle. Once the stems are removed, you can install the new stems. Once the stem is in place, reattach the faucets and handle.

If your old cartridge is made from brass, it may come with a retaining clip that prevents it from falling out. Using a screwdriver or utility knife, remove the retaining clip. Once the cartridge is removed, you can cut off the O-ring and spring. Next, clean the faucet housing to remove any debris and excess water. You should now be able to turn on the faucet again. Once you've removed the retaining clip, you should be ready to replace the old cartridge.

After you remove the old cartridge, you should clean the faucet housing. The housing has decorative covers. You should remove them if the screws are exposed. If the cap is made of plastic, remove it with your fingers or a flat-head screwdriver. Then, you can easily remove the screw and replace the new one. In addition to saving time and money, you can also save money when replacing the old one.

If your old cartridge is made of brass, it may be corroded and wear easily. It can also develop mineral deposits, causing the faucet to leak or become difficult to turn. Therefore, it is important to replace both cartridges of your faucet to ensure proper functioning. This will ensure the long-term durability of the faucet. It is vital to clean the water valve. It is located beneath the sink. After removing the cartridge, you must carefully clean the housing.